Most people here seems to decrease the default timeout s for these connections which results in other problems instead of increasing the maximum value. From what I understand you also have to increase the hash table where these are stored in order to benefit from this increase. In the older kernel this was not possible since one would have to set this value before booting and there was no nvram setting for that? Although in K2. Also since K2.
I have also used this as an example. I haven't found any way to permanently change the hashsize parameter. Although since you now in K2. Besides an obvious improvement in performance, there is a way to check via CLI the technical results:. The newer firmwares' V23SP2 and newer 2. For this method to work in later kernels, the timeout values must be placed in individual files. Few people know what this line actually does. It is a list for all possible TCP states and their timeouts in seconds.
See the table below they are in the correct order :. The following script should set these values automatically. Posted April 19, Hope this helps someone. Link to comment Share on other sites More sharing options Recommended Posts. Maximum Error Posted April 19, Posted October 27, This topic is now closed to further replies.
Go to question listing. Quick Links. Log in Profile View unanswered posts Log in Username:. View previous topic :: View next topic. I apologize if this has been posted before but I searched the forum and couldn't find any cases of slow speeds quite as extreme as mine.
I recently tried to flash my Netgear Rv3 with dd-wrt, but I noticed that afterwards, my download speeds were down in the kbps.
For reference, my ISP is fiber with Mbps, and while I was on Netgear's stock firmware, I was regularly getting mbps download.
0コメント